FUEL SAVER CHIP



Chiptuning Made Easy



- Door het installeren van Fuel saver chip in uw auto gaat u tot 27% 
  van brandstof besparen bij benzine auto's en tot 15% bij diesel auto's
- Met de Chip vermindert CO2 - uitstoot van uw auto gemiddeld met 25%

Do-it-yourself 4 wires simple installation




INSTALLING FUEL SAVER CHIP

Start by locating the OBD-II Port. It is usually located on the drivers side of the vehicle, just under the dashboard.


Attach the CHIP housing close to the OBD port using the included mounting tape and zip ties. 
Be sure that the front of the CHIP is visible, allowing the user to view the power LEDs if needed. 
Looking at the OBD PORT, check to see which pins are occupied. 
Occupied pins will have silver contacts inside of the hole.


Be sure that the wires behind the OBD PORT are accessable. You may need to remove the OBD PORT from its mount. 
This requires a screwdriver (in most cases). 
Using the included crimp connectors, crimp the CHIP wires to the OBD wires as follows:

Determine the Protocol:

Write  down which of these pins are populated: 2, 4, 6, 7, 10, 14, 15, 16.  
If pins 6 and 14 are populated, connect WHITE to 6 and GREEN to 15, if 15 not populated, 
connect GREEN to pin 5. If pins 2 and 10 are populated, connect WHITE to 2 and GREEN to 10. 
If pin 2 but NOT pin 10 is populated, connect WHITE to 2 and GREEN to 5.

ALWAYS connect RED to pin 16 and BLACK to pin 4.  DO THIS LAST

The CHIP should now be ON (lights working).  Reattach the OBD PORT to the mount on the vehicle.
PRESS the reset button (inside of the hole on the front cover). You may use a pin, or paper clip. 
Start the engine and let the vehicle idle for at least 3 minutes

DO NOT DRIVE OR REV THE ENGINE AT THIS TIME!  

Lights will flash during this calibration process.

If you change anything on your engine……….sensors, plugs, HHO, mist injection, K&N filter, then the CHIP MUST be reset.



Fuel Saver Chip with software modifications:

1. FS3 - Fuel Saver Chip (save 15% diesel and to 27% gasoline)
2. FS2 - Works with HHO Systems, fuel saving 40 to 47%
3. VP12 - (Chiptuning) provides extra 25 hp and fuel economy 2%

Chip software and firmware for above 1500 car's

For fast processing and programming Fuel Saver Chip, we need information such as 
car, make, model and year of vehicle - info





FS2 - HHO EDITION CHIP

FS2 - HHO EDITION CHIP



FS2 - Working with TiFGC System, Fuel saver about 50%
€ 181.50


FS3 - Fuel Saver Chip

FS3 - Fuel Saver Chip



FS3 - Works without HHO system, Fuel Saver about 27%
€ 181.50